Setup Remote Desktop Using DynDNS
Step 2
Assign a static IP address to the Home PC
Your home network will handle routing all of the Remote Desktop traffic to your Home PC, but first we need to assign a static IP address to your PC. Open the Control Panel by clicking Start, then Control Panel. Double click on Network Connections.
You may have several network connections in this box, depending on your configuration. But most likely you will need to modify the “Local Area Connection”. If you are unsure which one to modify, look for the one that is not grayed out and does not have a big red X on it. It doesn’t matter what it is called. If you are really brave, you can test to make sure you have the right one by right clicking on it and selecting Disable. Once it is disabled, you should no longer be able to browse the internet. If so, you’ve found the right Network Connection. (Now right click it and select Enable.) 
(see picture)
Double click on the “Local Area Connection” icon.
A box will appear with the name of the Network Connection in the title. It will be called the the “Local Area Connection Status” box. The “General” tab will selected. Click the “Properties” button at the bottom. (see picture)
The “Local Area Connection Properties” box will appear. You will need to scroll down inside the white box until you see “Internet Protocol (TCP/IP)”. Select this and click the “Properties” button. (see picture)
In the “Internet Protocol (TCP/IP) Properties” box, your setting is probably on “Obtain an IP address automatically”. This means that on your local network, your private IP address can change from time to time. Normally this is okay, but if we are going to start telling our network to point all Remote Desktop Connection traffic to this PC, it needs to be using the same IP address all the time. So click “Use the Following IP Address”. (see picture)
You shouldn’t just guess what IP Address to use, or you’ll have a hard time with your local network down the road. Instead, go back to the “Local Area Connection Status” box (it should still be open) and click the “Support” tab. Your current IP address, Subnet Mask and Gateway will be in this box. Change the last number in your IP address to an IP address that is below 100, but not 0 and not 1. It should be an IP address that is not in use. (192.168.1.3 is generally safe) If you want to be sure that the IP Address is not in use, open a command prompt (Start-> Run -> type “cmd” and hit enter) and type “ping 192.168.1.3″. If it says “Request Timed Out” then the IP address is not already in use and you are safe to use it for your PC.
Enter this new IP address and the values for Subnet Mask and Default Gateway into the “Internet Protocol (TCP/IP) Properties” box that you were just on. Where it asks for “Preferred DNS Server”, enter the value that you used for the Default Gateway (it will probably be the IP address of your Router, most likely 192.168.1.1 or 192.168.0.1). (see picture) Now click OK to all open boxes until you are back at the Network Connections box. Your network connection will now refresh. When you double click on the “Local Area Connection” icon in Network Connections, you can click the Support tab and see the new “Static IP Address”.
Next Step: Open a Port in the Router’s Firewall to Allow Remote Desktop Requests
Related posts:
- Set a Static IP Address in Windows XP
- How to Show Picture Tasks in Windows XP
- Sharing iTunes with Multiple Users
- Run a Batch File Invisibly
- Automatically Upload Photos to Flickr
Comments
One Response to “Setup Remote Desktop Using DynDNS”
hey brock…nice site..good to hear from ya…